Audio installation bother arguably easy. So here goes klo buy head unit or buy electronic devices for cars already equipped with installation instructions. Armed with little knowledge of electronics when the first secondary school until high school I think you all can do it, that distinguishes his work is probably only just the level of neatness.

Storing the audio is one of the most unpredictable, sometimes results in the cable installation is neat, all the connections at each point using a solder, and a good insulator, but tau-tau spark plug wires and causing trouble storing, like guns that would spark plug wires leak had to be replaced so as not to cause interference to the audio system.

Storing can be caused by some of the following:
1. Cable connection between too much and do not tidy.
In cabling, try not to connect the cable too much!, It is important to detect the level of damage in the future. Use solder to strengthen the cable connection and use insulation (isolation) of quality.

2. Ground cable, each unit on an audio device requires a good ground, make sure the groud position is not reached by the hot spot, and its surface does not rust.

3. Leakages in the spark plug wires, it rarely happens so it is still less attention, is to replace the road satu2nya spark plug wires.

4. There are some Electronic Control Module that emits signals that can lead to stooring, usually the signal is called the RF signal